Alert Security Systems

[misterdee]

I have been running six cameras on my network for a year and they work great. Now I would like to add one of the new indoor cameras with the understanding that Commander will only support six. Do I just have to load Commander on another computer on the network to control that seventh camera?

[SteveGB · Accepted solution]

misterdee.

Try the following link.  Read the thread. It should answer your question.

http://forums.logitech.com/t5/Alert-Security-Systems/Multiple-Master-systems-possible/m-p/513196#M88...

Steve

[misterdee]

Thanks, Steve,  that was what I was looking for! 

[ejnel]

I followed the linked instructions. Bought another master. Installed Commander on another PC. Plugged in master but no light on router showing it is connected to internet. Plugged in camera; get two red lights on front showing power but no light at all on bottom front  Diagnostic to show recording. Also no light on bottom center, Motion LED. Tried to reset, no change. Instructions said to add a new Security Key but when I was a warning came up saying to install all cameras first. So basically nothing works.

I have nine camera plugged in. Six show up on my PC and eight show up on the Logitech Alert page. But the brand new ninth one is dead.