Reply
Logi Nu
Mustang4
Posts: 3
Registered: ‎11-13-2008
0

Cordless controller works then stops

I have a cordless logitech controller for my xbox and what it is doing now is, it will be usable for about a minute (the red led is blinking the entire time) and then the controller will just die and be unusable until I take out the batteries and then it will do it again.  the batteries are new so it's not that.  any suggestions or ideas?

Thanks,

Dan

Moderator
CharlesB
Posts: 4,196
Registered: ‎07-06-2006
0

Re: Cordless controller works then stops

The batteries might be new, but that doesn't remove the chance the batteries might be defective. I'd try a different and fresh pair of batteries.
Logi Nu
Mustang4
Posts: 3
Registered: ‎11-13-2008
0

Re: Cordless controller works then stops

I've tried 3 different sets that were all good. so i know thats not the problem  is there anything else that I could try, like exactly what is the procedure on "connecting" the logitech controller to the plug in at the box?
Moderator
CharlesB
Posts: 4,196
Registered: ‎07-06-2006
0

Re: Cordless controller works then stops

To reconnect a controller:

 

Press the button on the receiver (The weird horseshoe crab shaped thingie)  then press any face button (a,b,x,y) on the controller

You can also perform a receiver reset by holding down the connect button for 10 seconds, then pressing a face button on the controller

Logi Nu
Mustang4
Posts: 3
Registered: ‎11-13-2008
0

Re: Cordless controller works then stops

reconnecting doesn't seem to be working.  what happens is when i put the batteries in and hit any button it will blink one time each second for aprox. 43 sec which is about 43 sec. then it turns off and i have to take out and put the batteries back in to do it all over again.  reconnecting it didn't do anything.  its wierd that it will work for a short period of time then cut out.  any other ideas?