Game Consoles PS2 - XBox - Nintendo

[apok8402]

Having a problem with my controller.  When I stick in the receiver to my PS2, the green light blinks.  When i put in new batteries into the controller, the red light comes on for about 5 seconds, and then blinks as well.  It seems like there is no communication between the receiver and the controller.  Any suggestions on how to correct?  Thanks!

[sdafgfdgd]

Hello apok8402,

Please refer to the following instructions to reconnect your controller.

1. Press the button on the front of the receiver. The LED on the receiver should then start blinking.

2. Then press a few button the gamepad. When connected the LED on the receiver should glow solid.

Note: When you are pressing the mode button on the gamepad you should see the LED next to the button turn off and on. If the LED on the gamepad does not light, the most likely cause is the improper installation of batteries.

I hope the reconnection procedures above resolves your issue.

[DeeZi]

My receiver blinks green and when I go to press buttons, the mode light flashes just once, then nothing.  The receiver light continues to blink.  Vibration works though so batteries are installed properly.  Any help?

Message Edited by DeeZi on 08-21-2007 12:43 PM

[PHOENIXZERO]

Press the button on the receiver and then hold down the Mode button for a few seconds and see if that fixes it. I had a interference issue a few months ago and that cleared it up.

[kai4realz]

im having the same problem sort of my reciever keeps blinking but not responding to my controller