Harmony Remotes - Hardware

[LittleDeuce]

I have a BEV 6100 and recently purchased the Harmony  One remote.

My remote for the BEV is apparently RF only (I cannot see anything that is marked otherwise - says UHF Pro on the remote).  I am given to understand that the BEV receiver will accept both IR and RF signals.

How can I program my Harmony One to control the BEV unit without having an IR remote for the unit?  

Thanks in advance for any help.

[WannabeActuary]

you'll have to use the original remote to navigate the menus of the device and if possible, change the settings on the device itself to IR.

this should be covered in the bell manual...and other than looking at the manual myself (given that I don't have the device), you should be able to do that yourself.

from there, your harmony should work fine to control it