Harmony Remotes - Programming

[DGG]

My remote does not seem to be sinced with the screen . But since it is not when I go to the remte screen from the wrench I con I cant run the screen set up. Any ideas?

Also has anyone experienced a conflict with extender and wireless mouse being near each other?

[hhatkin]

Let us have more details so that we can look into this for you.

[DGG]

Its like the butoons are not in the right place. sya i try to press "ok" whatever the corresponding pad or diode is its not under the "OK" icon same same with page, number pad etc. 

[hhatkin]

OK - the screen buttons do not correspond with the location of the commands.

Does that apply to all screens in all Activities?

[acydlord · Accepted solution]

Sounds like you need to recalibrate the screen. Remove battery, press and hold off while replacing battery, once in safe mode remove and replace battery without using the off button, you should get a screen calibration prompt then.

[DGG]

Any thoughts on the conflict with the logitec wireless mouse?

[acydlord]

wireless mouse and extender shouldnt intefere with eachother, the extender runs from 800-900mhz depending on country, the wireless mice run on 2.4