Harmony Remotes - Programming

[sirandrew71]

My Harmony 700 seems to be unable to properly handle HDMI 1 input on the Samsung LE40M71B as a direct command.
So far I used a partial workaround using the 1st input mode (cycle through the existing inputs), although sometimes it get it wrong and I have to use the Help function until it cycle to HDM1.
I would like to understand whether this is a limitation of the remote/TV combination, or there is a way to use the "InputHDM1" command. All other input commands work fine when I go to the Device mode on the remote and select Ext1. Ext2, HDMI2...but selecting HDMI1 just does not work (the input is set to HDMI2 if I select the "InputHDMI1" command).

Any suggestion?

Thanks in advance,

Andrea

[sirandrew71]

anyone out there?

[Taylarie]

Please note that these forums are meant to be a Peer to Peer assistance forum. In other words, other people assist others with their experiences and knowledge of products. You will find some Support Representatives from time to time but they are not mandated to offer assistance.

[sirandrew71]

thanks, got that, was just pinging to see wheter anyone had my same problem or could help.

[hhatkin]

The first thing to do is test all the other commands starting with Input - there are a lot of them! - to see if any of them actually sets the one you want.

[sirandrew71]

Thanks...done that. All others input works fine...but none sets the TV to HDM1.

[towboy123 Logi Legend]

set the Activity that uses the input to the previous input then add an additional input next command to the start of the Activity here

Activities>Your Activity>Settings>Review Settings>Yes but I want more control>Save>Next...until the custom Actions screen>add it here