Harmony Remotes

[rhachey]

No, you can't modify the All Off Button, if you are using the 7.7 stand alone software, you can add additional commands to the ending of beginning of your Activity.  If you are using MyHarmony, there is no way to add additional commands to either the start or the end of your activity.

[idicev]

---

n8leon wrote:

... I am currently using the TiVo model TCD-652160

The Harmony software also has the PowerToggle option for this model,

which I have mapped to the "red" button under WatchTV activity.

That works, except I have to push "red" then "All Off"...

---

n8leon, if you don't want to use a Device and an Activity for the Tivo you are stuck with having to put it into standby manually. This is because the Harmony can only remember the Tivo's standby status for use in 'All Off':- a.) if it Knew what the equivalent command was for the Tivo device,and b.) if it had also previously switched it by using an activity containing the Tivo device in the normal fashion.

The alternative is:- Instead of pressing a red button from Watch Tv, if you use a separate Activity to start the Tivo, just the same as Watch Tv but with the Tivo Device added (including the previously red button command to serve asboth the 'Power On' and 'Power Off' toggle for the Tivo), then All Off will work to put Tivo into standby when necessary (i.e. if it was not already in standby) together with turning everything else off, just as normal.

Chris

[RonNova]

Since you have tried to mapped the powertoggle command on the watch tv activity and it placed your TiVo to Standby, Change the PowerSettings of the Cablebox to Power On and Power Off then select the PowerToggle to turn the cablebox on and off 

Devices ---> Settings of the Cablebox ---> Adjust PowerSettings ---> I want to turn off this device when it's not in use ---> A button on the remote for On, and a different button for Off ---> ( Which command will Power On your device?)  I don't have the original remote, but I know the command that is used: Select PowerToggle ---> ( Which command will Power Off your device? ) I don't have the original remote, but I know the command that is used: Select PowerToggle  

That should be solving your concern. 

Regards 

Ron