02-27-2011 08:37 AM
I have a harmony 900 controlling my TV (IR), PVR (Blaster) and have just added an Apple TV (Blaster). When I am setting up which devices I would like to be controlled by the blaster on the remote, only two devices are displayed (TV and PVR). There are two pages shown, but the ability to switch between those pages is not being shown.
To get the remote working with the Apple TV in the meantime, I deleted the TV from the device list so that only the PVR and Apple TV would be displayed and assigned it to be controlled by the blaster. Then I readded the TV, but still cannot switch between pages.
Everything is working properly right now, but is very inconvenient to have to do this for future devices.
Any support would be greatly appreciated.
Solved! Go to Solution.
02-27-2011 12:17 PM
I would try doing a Firmware update in safe mode. To put your 900 in Safe mode, remover the battery, then while holding the Off button, replace the battery, the LCD screen should say Safe mode. Connect your remote to your PC, and logon to your account, and click the download link and do a Firmware update, followed by Updating your remote.
02-27-2011 02:12 PM
Just finished doing the firmware update, updated remote and rechecked. Same result unfortunately, there is no ability to switch between pages of the devices controlled by the blaster.
02-27-2011 03:58 PM
There are two pages shown, but the ability to switch between those pages is not being shown.
If you can't switch between them how are they being shown?
Do you mean they OUGHT to be shown?
02-27-2011 05:58 PM
Normally when a list of devices is displayed there is an icon in the top left corner which shows 1/2 or 2/2 etc. representing the page being displayed. When this happens, there are white arrows which are displayed on the left and right of the screen which enable you to switch between the pages.
My remote does not display these arrows which is why it has become such a pain to work around assigning devices to be controlled by the blaster.