Harmony Remotes

[blahblah65]

Hello,

I have my Harmony One set up fine for the most part. One thing I'm having issues with is that I want to be able to go through the internal settings on the Marantz 6003 so that when I'm watching either a TV or DVD I can switch between the HDMI Audio going through the TV or the Home Theatre Speakers connected to the receiver, without using the Marantz remote.

I cannot figure out how to do this with the Harmony One.

The Marantz remote would use these commands.....  "Menu" --> down 4 clicks ---> "Preference" --> "Enter" ---> down 6 clicks ---> Right or Left arrow to change "HDMI Audio" ---> "Exit"

Any thoughts on how to set up an activity to change just this setting whenever I want without power cycling anything?

Thanks!

[rhachey]

Harmony One can do Sequences, but it is limited to 5 commands, you have 15 commands listed.

[blahblah65]

I've tried setting up a 5 step sequence with 3x3x3x3x2 "learned" remote clicks from the Marantz remote, but it just isn't working. It always dies after the first step.

Is there no solution for this? This remote was not cheap so I'm unsure of why people would buy it if you cannot do "deep" commands to run your system how you want to.

[blahblah65]

I'm waiting to hear back from Harmony Support but I may have found a work around going in the opposite dirtection of arrows on the Marantz remote.

Using custom "Learn Raw" commands I have the following sequence now for a custom button:

Menu -> UP, UP -> Enter, UP -> UP, UP -> Right, Exit

I wish there was a way to also have this button swap which device (TV or Receiver) controls the volume, but for now I just set up 2 additional activities for a total of 4.  (TV&DVD w/ TV volume control and TV&DVD w/ receiver volume control)

Is there a more graceful way to accomplish this?