04-20-2012 03:45 PM
Harmony One with a media center device (popcorn hour c-300) I have evreything set up fine as far as use but when I choose it in my activity set-up the device will turn on and function correctly but then it goes right to the next selection on the device itself.
So it goes like:
1. choose activity is ok
2. Inputs switch & device turn on correctly
3. device makes the next "selection" on it's own without input from the remote
What I'm not sure is this a situation where I have to adjust what? The inter-key, delay, power on delay etc.??
04-24-2012 12:36 PM
You mentioned that devices are turning on correctly and going to the correct input but is going to the next selection. Which selection are you referring to? Can you explain further which command is being sent? Also, kindly try to check the original remote if it is doing the same thing. If it is, then it is a device issue. There is also an option to add a functionality in the activity to make it go back to the selection that you want. You may follow this link:
Adding commands to be sent at the start or end of an Activity for a Harmony Remote