Harmony Remotes

[joffet]

I have a Harmony 650 and a Samsung HP-P5071. The power-on delay is way too long. However, this device doesn't have a power-on delay setting in the Remote Software (7.7 Mac Version).

Any suggestions?

[triad]

All devices have power on delay settings in the 7.7 software. You can't change any delays in the MyHarmony.com software. Go to the device, the adjust delays. Power-on is the first one listed. In my experience, these delays are usually correct by default. So you may want to manually turn on your device and find the minimum time before it will accept new commands. If the delay is too short, your activities will fail to select the correct inputs if your tv isn't already on.

EDIT: Above only applies to models EXCEPT the 600/650/700 as noted below.

[rhachey · Accepted solution]

The Power On delay for the 650 is in the remote and not in the software.  Hold the Help Button for 5 seconds to get to the Advanced settings, here the Power On delay and the Inter-devices delays can be set.  This is also true for the 600 and 700 remotes

[joffet]

rhachey, you are the man ... assuming you're a man ... whatever, thanks for the tip

[triad]

Good catch. I just looked, and by George, they aren't in the software. This is a very good thing. That means myharmony.com users can adjust power-on delays too.

I'll edit my other post so there's no confusion.

[rhachey]

Glad I could help, and yes I am.