- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
DiNovo Edge and MX Mouse
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
04-23-2012 12:49 PM
I just purchased a DiNovo Edge keyboard and like it thus far. I don't particularly care for the touchpad though. Is there a way to install a mouse with this keyboard. I have a MX mouse that I would like to use. I am using the dongle that came with the DiNovo keyboard to connect to the computer and cannot get the mouse to connect to it. Is there any way to get this combination to work?
Any Help will be greatly appreciated.
Benny
Solved! Go to Solution.
Re: DiNovo Edge and MX Mouse
[ Edited ]- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
04-24-2012 08:17 AM - edited 04-24-2012 08:34 AM
Hi BigRedGonzo,
What exact mouse do you have? (You can look for a P/N or M/N on the bottom or in the battery compartment). Does the mouse have the orange unifying logo on it, the same as the Edge? (It looks like an orange gear).
If it does, you will have to use the unifying software to pair the mouse with the DiNovo Edge receiver, but if the mouse is not unifying, it is not compatible with that receiver and will require it's own.
Regards
If a reply adequately addresses your technical issue, please click on the "Accept as Solution" and "Give Kudos" button so this information can benefit other users via search.
Re: DiNovo Edge and MX Mouse
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
04-24-2012 11:54 AM
Thanks for the help, It is an older mouse so I plugged the old receiver back in and it works fine now, as does the keyboard. Thanks for the help.
