MyHarmony.com

[anderkh]

This device is a 4 zone 4 source switcher.  There are 16 discreet codes to set each input and output (ie: Zone 2 Source 3).

When setting up in MyHarmony, the device only lists 4 sources, and the codes it sends are always for Zone 1.  However, when I look at the device itself, it lists all the functions properly.

The only way I can get this to work is to tell the activity that it's not working, and to scan the correct code myself.  Is there any way to tell it to just use a different code that the one it's assuming?  How could Logitech say they support this component if it only works for Zone 1?

Thanks,

Ken

[Cristian_N · Accepted solution]

Hi Ken,

The way Logitech is supporting MultiZones on the Harmony remotes is through multiple devices. So, if you need to use the other zones all you need to do is add them as separate devices with these model numbers:  "HD44CC5 (Zone 2)", "HD44CC5 (Zone 3)" and so on. 

[anderkh]

That worked perfectly, thanks!  Without being able to see a list, I had no idea it worked that way.

Thanks again,

Ken

[eddadams1]

Very helpful info. Thank you. I have 3 zones with 3 directv receivers running within the HD44CC5.  3 Screens on 1 wall in the same room, all into a Denon AV receiver.  Is there anyway to program the Harmony 1100 to switch screens, sound and directv receiver functions within the same activity? Or will I just have to set more activities? Any help much appreciated.

eddadams1