09-07-2011 01:08 PM
Unfortunately the G25 shifter is not compatible with the G27 wheel.
09-13-2011 11:35 PM - edited 09-14-2011 11:09 PM
Ah Yes you CAN I am doing so,
While the G25 to G27 Shifter Units are not directly compatible ie Plug into each other the method of making it so is so bloody simple it's laughable.
Logitech must think all us racer's are rather stupid. I started investigating this since pots were not available from Logitec and I have since found a suitable replacement.
Now apart from the obvious sequential mechanism components the electronics of the G25 and G27 Shift units are Electrically IDENTICAL in fact if you have the mechanism from an old G25 shifter then by drilling one hole for the LED and soldering in a microswitch to turn the LED on and switch the chip from 3rd and 4th to 1st and 2nd as shown on the Calibration GUI in Windows then you G27 Shift has morphed into a G25 .
To get your G25 Shifter working as part of your G27 System all you need to do is a VERY basic rewire of the DB9 Socket on the Shifter Cable.
As shown in the diagram below the G25 Plug is wired ever so slightly different with a jumper linking Pin 9 to Pin 1 and a Purple wire on Pin 7
Where as the G27 has Pins 9 and 7 linked with the purple wire moved to Pin 1 .
To make the G25 Shifter compatible with the G27 Wheel you remove the wire link from Pin 1 and solder it to Pin 7, linking Pins 9 and 7
The Purple wire currently on Pin 7 gets soldered to Pin 1.
Thats it your done.
See the image below.
If you want your G25 Shifter to work with the G27 Wheel you wire your G25 Shifter Cable as indicated in the bottom G27 Diagram.
If you want your G27 Shifter to work with the G25 Wheel then re-wire the Plug on the G27 Shifter Cable as per the G25 Diagram.
PLEASE bare in mind the Colour substitution difference between the G256 and G27
Pin 5 G27 White = G25 Red
Pin 9 G27 Red = G25 Black
ALL other wire colours are identical and go to the exact same pins inside the Shifters.
04-15-2012 01:51 PM
I have a problem with my G27 gear
3 and 4 are inserted only in transmission.
writes in first gear when I inserted the three.
three writes the fifth gear.
shift into second gear when I inserted the four
6 and 4
only just three and four.
No other gear.
I could not find how to have a problem.
these things are happening at the hardware specifications. setting up more.
04-15-2012 01:54 PM - edited 04-15-2012 01:56 PM
Logitech G27 gear configurations, the configuration file is missing
Config file contains the mappings of G27 manual is not shipped gearshifter. This is a serious problem, but not the problem. Missing parts: Control - reverse = "(1, 46)" Control- The first threaded = "(1, 40)" Control - The second threaded = "(1, 41)" Control - third gear = "(1, 42) "Control - The fourth gear =" (1, 43) "Control - Fifth Gear =" (1, 44) "Control - the sixth gear =" (1, 45); "
I read somewhere that I wonder cure for my problem, will you?
which this adjustment is made to the file ?
solves my issue?