- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
MOMO Force Feedback wheel makes my laptop go into blue screen when I try to install it.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
04-14-2009 10:56 PM
I have Windows XP Home Edition SP3 and have downloaded the latest Logitech Gaming software v5.04. Upon installation, when I am prompted to connect the USB cable and make sure everything is well connected, my computer goes into blue screen a second after I plug in the USB cable. The blue screen says:
"A problem has been detected and Windows has been shut down to prevent damage to your computer.
An attempt was made to execute non-executable memory.
If this is the first time you've seen this Stop error screen, restart your computer. If this screen appears again, follow these steps:
Check to make sure any new hardware or software is properly installed. If this is a new installation, ask your hardware or software is properly installed. If this is a new installation, ask your hardware or software manufacturer for any Windows updates you might need.
If problems continue, disable or remove any newly installed hardware or software. Disable BIOS memory options such as caching or shadowing. If you need to use Safe Mode to remove or disable components, restart your computer, press F8 to select Advanced Startup Options, and then select Safe Mode.
Technical information:
*** STOP: 0x000000FC (0xBA5038E8, 0x0AC30963, 0xBA503848, 0x00000001)
Beginning dump of physical memory
Physical memory dump complete.
Contact your system administrator or techinical support group for further assistance."
I have already tried to install the wheel three times and have had the same blue screen results. Every time the blue screen has appeared a couple seconds after I plug in the USB cable.
