Remote Control Software

[CstrMstr]

I just bought a Panasonic TC-P60ST50 and am trying to get my Harmony One remote to work with it.  I entered the model number in the setup software, but the system only comes up with the TC-P50ST50 (which is the exact same TV, just a smaller size).  All of the commands work as expected _EXCEPT_ for the IR command for switching the input directly to Cable/Ant.  All of the other input IR commands work (e.g. switch to HDMI1, HDMI2, etc).  This makes it a pain to watch cable TV. 

I would program it from the remote that came with the TV, except the remote doesn't have a 'switch directly to Cable' button...only a button to cycle through the inputs.  Am I out of luck on this or is there a way around it?

[FredV]

I have the TC-P50ST50 and it does have a TV (cable/ant) button right next to the input button. If you don't have one you can get around it by adding a custom sequence button.

Start the seq. by going to an input that does work e.g. "InputHdmi2" and then add a "DirectionUp" or "DirectionDown" step. Repeat the Up/Down step until you reach your desired input. The last step of your seq. should be "Ok(OK)".

I use this procedure to set the input to AV2. That particular IR signal doesn't work for me. Hope that helps.

Cheers,

Fred

[etzeppy]

The TC-PxxGT50 has the same problem. The command for direct selection of Ant/Cable Input does not work. Plus there does not seem to be a direct command for PC input in the database. I know a sequence can be built but is there a way to get Logitech to fix this. It is a current production line. It is kind of silly to have to build work arounds.