Remote Control Software

[thinkfire]

I have a Sharp Aquos LC-C4254U.

It has the following inputs on the TV.

TV

Input 1

Input 2

Input 3

Input 4

Input 5

Input 6

Input 7 (PC)

On my Harmony 620 remote, I only have availble to me:

Input 1

Input 2

Input 3

Input 4

Input 5

There is no TV, Input 6, on Input 7 (PC).

I cannot program them from the manufacturer remote, the remote that comes with the TV does not have independent input buttons.  Just 1 input button that cycles through them all.

How do I go about getting Input 6 and Input 7 (PC) to work?  I have my PC hooked up to Input 7.  Nothing on 6.  I cannot program it to cycle the inputs because it gets confused when the TV disables an input when a device is no longer sending signal to it.  I have to use indepent input commands for it to get it right all the time.  As of now, all my activities work fine except my PC one because of not being able to select the proper input.

I have seen some posts from other Aquos users with the same issues, different model numbers.  Where they have more inputs on the TV than shows on the remote.

[OmarHarmony]

Hi,

I was able to find your Harmony account and I have added a few extra input commands (Input6, Input7, Input8, Input9, InputAntenna2, InputAntennaA, InputCard, InputiLink, InputPC, InputTV) for you to test.

To test these, follow the steps outlined in this FAQ.

Regards,

Omar