Speakers

[pypy]

Hello,

I just set up my Z-5500 and ran the test from the remote. All speakers sound good.

I then hooked it up to my SB Audigy ZS sound card but I only get sound from the Speaker 1 Out port through the Front speaker cable (green). Even though that's designated as the port for the Front speakers, sound plays through all 5 speakers, and when I remove it or switch it to another one of the 3 cables, I get no sound whatsoever.

Could this be a problem with my soundcard settings or am I not connecting it correctly?

For reference, the ports are listed further down on this page: http://h10025.www1.hp.com/ewfrf/wc/document?docname=bph07905&lc=en&dlc=en&cc=us