This morning, I installed my Logitech QuickCam Communicate STX and after rebooting, my display had changed and I could not get the QuickCam software to launch. I have multiple displays on my Dell Latitude D610 and now I have two displays that are mirrored and my 3rd display acts like it is the extended desktop. Before isntalling, all three were in extended desktop mode. With the QuickCam software, I have tried to see if the process comes up and it does, but for only a second.
Welcome to the Logitech Community Webcam Forum jwil51!
Please contact Logitech Support directly for further assistance.
KachiWachi - Webcam Forum Guru (2002), Logi Legend (2007), Distinguished Logi Legend (2010), QuickCam® Team Forums (2007)
(I am not affiliated with Logitech®, Inc., Lithium™ Technologies, Inc., RightNow® Technologies, Inc., or Salesforce.com, Inc.) Have you checked your Logitech Forums Private Messages today?
If you are looking for official Logitech Customer / Technical Support, please >> CLICK HERE <<
In order to help keep the forum content "fresh", please do not post a reply to any thread that is over six (6) months old.
* As of October 1, 2015, I will be providing "general" troubleshooting assistance in the public forums once 24 hours have passed. * Also, if I do respond to your issue, and for all "advanced" issues, please check to see if I have sent you a Private Message as well. * Thanks.
* PS - If one (or more) of my replies has adequately addressed your issue, as a thank you, please click on the "Accept as Solution" and "Give Kudos" buttons, so that this information can benefit others.