Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
0
Streampoin t 1.5, windows XP will not run the setup wizard after install
[ Edited ]
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
03-21-2008 06:57 PM - edited 03-31-2008 08:33 PM
Hi,
I have tried installing streampoint 1.5 from the disk however after getting pass the finish button to go into the configuration utility nothing happens. I have manually tried to run the streampoint setup wizard and again nothing happens. I have installed .NET framework from the disk and ensured all firewalls, antvi-virus programs are disabled. Anyone seen this king of issue with XP and have any advice?
Thanks
Ray
No response so far - and Logitech support has been useless... anybody have any idea what I can try. The streampoint logs seem to show this is a .net permission error?
Message Edited by rayowenuk on 03-31-2008 08:33 PM
0
Re: Streampoin t 1.5, windows XP will not run the setup wizard after install
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
07-03-2008 03:52 AM
Hi, I have the same problem. Just wondering if you managed to fix it? Was it the .NET?
