io - General Discussion

[sergej]

Thanks Brijesh,

I think I'll have no more problems from now, but I had to change my pen...

I'll try to develop something in these days, I will bring you up to date.

Thanks to all

Sergio

[Nigel2007]

Hi Brijesh

I am having the same problems a Sergio, using paper that I have printed myself. I have printed out the file "PC Data Demo LaserW.ps" from the Anoto SDK, and I get the same results as Sergio! The pidgets work OK, but when I press the pen down anywhere else on the paper, the pen vibrates and the memory LED flashes RED.

The TC number is only partially printed on the page, as "TC:2743SELFPRINTED". Note that the pidgets are printed over separate background pattern areas, rather than being printed over the drawing area, as usual. Looking in the PAD file, I see the page addresses are as follows:

Drawing area: 50.0.2.0
Pidget - Blue: 0.1.2.40
Pidget - Black: 0.10.0.0
Pidget - Red: 0.1.15.40
Pidget - 0.3mm: 0.2.0.0
Pidget - 0.6mm: 0.2.0.0
Pidget - 1.2mm: 0.2.0.0

My pen is a Logitech IO2 USB pen, p/n:866203-0000, with firmware version 38.16 Consumer.

I, too, would be very grateful if you could send me the PDF file, so that I can try that with my pen. My email address is nigel.evans(at)logi.co.uk

Kind regards, Nigel

[Brijesh]

Please try those papers with new IO2 BT pen and check. I will send PDF to all ( who requested) after one week or so - as i am currently in UK for my training purpose.

Message Edited by Brijesh on 01-18-2008 08:38 PM

[zanyguy]

hi Brijesh,

Can you pls send me the Nokia PDF as well? It seems that the new version of the phone does not come with these and buying special notebooks seems like a waste of money...

TIA!

Nick

[Brijesh]

Sorry Nick- I don't have Nokia PDF with me.