01-17-2008 08:48 AM
I think I'll have no more problems from now, but I had to change my pen...
I'll try to develop something in these days, I will bring you up to date.
Thanks to all
01-17-2008 01:04 PM
I am having the same problems a Sergio, using paper that I have printed myself. I have printed out the file "PC Data Demo LaserW.ps" from the Anoto SDK, and I get the same results as Sergio! The pidgets work OK, but when I press the pen down anywhere else on the paper, the pen vibrates and the memory LED flashes RED.
The TC number is only partially printed on the page, as "TC:2743SELFPRINTED". Note that the pidgets are printed over separate background pattern areas, rather than being printed over the drawing area, as usual. Looking in the PAD file, I see the page addresses are as follows:
Drawing area: 184.108.40.206
Pidget - Blue: 0.1.2.40
Pidget - Black: 0.10.0.0
Pidget - Red: 0.1.15.40
Pidget - 0.3mm: 0.2.0.0
Pidget - 0.6mm: 0.2.0.0
Pidget - 1.2mm: 0.2.0.0
My pen is a Logitech IO2 USB pen, p/n:866203-0000, with firmware version 38.16 Consumer.
I, too, would be very grateful if you could send me the PDF file, so that I can try that with my pen. My email address is nigel.evans(at)logi.co.uk
Kind regards, Nigel
01-18-2008 07:07 AM - edited 01-18-2008 07:08 AM
Message Edited by Brijesh on 01-18-2008 08:38 PM
02-04-2008 05:12 PM